Repairing Holes in Window Screens

Replacing a damaged section or an entire screen can be done with tools usually found around the home and by do-it-yourselfers. This also will help with keeping insects out of your home.

Several different materials are available for screening including aluminum or plastic which are nearly permanent against weather. Galvanized iron screen was used in the past but this material will rust over a period of times and should be replaced before it discolors the window frame and wall.

Screen fabric comes in different widths so choose the width that will cover your frame with the least waste.

METHOD 1

Step 1. - Cut a patch of screen which will cover the hole at least 1" on all sides.

Step 2. - Unravel a long piece of screen wire or several pieces and lace it through the patch and screen.

METHOD 2

Step 1. - Cut a patch large enough to cover the hole with about 1-1/2" around all sides and unravel all sides of the patch about 1/2".

Step 2. - Bend the ends of the wire 90 degrees to the patch and push them through the screen covering the hole. Bend over the wires projecting through on the back side to hold the patch.

Article Credits & appreciation

Additional DIY Resources

• Home Maintenance for Dummies
• HandyMa'am (TM): Home Improvement, Decorating, & Maintenance Tips & Projects for You and Your Family
• The Virgin Homeowner : The Essential Guide to Owning, Maintaining, and Surviving Your Home
• New Fix-It-Yourself Manual

Want to get published?

Contact us to submit an article to be listed on our website.

This article does not necessarily reflect the views of 411 Home Repair, and is only a suggestions and/or comments submitted to our site to share with our site viewers through the world wide web.