Rockler Chamfer Reversible Rail & Stile Router Bit - 1-5/8"e Dia x 15/16"e H x 1/2"e Shank
|For those who make cabinet doors only occasionally, this cutter provides an affordable, space-saving solution to routing cope and stick joints. One bit cuts both rail and stile profiles; just remove the cutters and rearrange them to go from coping rail ends to routing grooves in the stiles. Because the bit is bearing-guided, you can also rout arched rails without a template or fence. Available in Chamfer, Ogee and Classical styles (27190, 23422 and 27602, respectively). 1-5/8"e diameter x 15/16"e cutter height x 1/2"e shank. 5/8"e bearing. Groove is 3/8"eD x 1/4"eH. Instructions for Routing:To cut the groove and profile on the insides of the rails and stiles, run stock face down on table. Stack the bit (starting from the shank end) as follows: profile cutter, straight cutter, then bearing.To cope the ends of the rails, run stock face up on table. Stack the bit (starting from the shank end) as follows: straight cutter, bearing, then profile cutter.IMPORTANT SAFETY NOTE: Do not invert any of the cutters! Be sure the carbide is facing the right direction for the rotation of the router.
Only $69.99 at Rockler.com